5508 wlc HA redundancy management vlan

Advertisement
  • 5508 WLC HA pair - change management interface settings

    Hi, We have a pair of 5508 WLC's in a HA configuration that is working well at the moment, however I have noticed that the management interface is configured as untagged. I would like to change this to tagged and change the attached switch to trunk f

    November 30

  • 3702i AP's not Joining WLC - Layer 3 discovery request not received on management VLAN

    Hi Guys,  This is a follow up post to this thread: https://supportforums.cisco.com/discussion/12400481/3702i-not-joint-2504 Have been playing around with my AP's and made sure the time is correct on all the devices ( WLC and Switch). I have also move

    October 11

  • I have a Problem with Romming Between SSIDs withing the same WLC but with deferent VLAN .

    HI All, I have a Problem with Romming Between SSIDs withing the same WLC but with deferent VLAN . the WLC are providing the HQ and one of the Branches the Wireless services . Am using all the available 9 SSIDs at the HQ , and am using only 4 of it at

    October 11

  • N+1 5508 WLC failover test

    Good day all, I have a question about the N+1 5508 failover test: Should I shutdown one of the primary WLC to test failover? I just setup the N+1 bakcup WLC (5508). B Based on: http://www.cisco.com/en/US/docs/wireless/technology/hi_avail/N1_High_Avai

    October 11

  • Redundancy management IP and Redundancy port IP unreachable issue

    Hi, all I got one interesting issue with wireless 5508 controller. we have ordered two WLCs, one is air5508-12-k9, Anther one is air5508-HA-k9. Now, we are going to form HA mode and HA box will become standby mode. One issue we are seeing now. after

    October 11

  • HA in 5508 WLC running 7.3 image

    Hi , For configuring the HA between the WLC we will be configuring these in both controllers 1)management ip 2)Redundant management ip Once HA is done , standby wlc will get all the configuration including management interface ip address.So the Activ

    November 30

  • Can't put two 5508 WLCs in the same RF group

    Hi experts, I have two 5508 WLCs and I want them to be backup to each other. I put in the same "RF Group Name" and even the same "Default Mobility Domain Name" however under Wireless -> 802.11b/g/n -> RRM -> RF Grouping each c

    October 11

  • Clients unable to connect and get DHCP - LAP1142N AP and 5508 WLC

    Hi, I have 19 locations, each with 1 or more LAP1142N AP's in FlexConnect mode, AP's are primed using CAPWAP to my 5508 WLC at the datacenter. The AP's join the WLC without issue every time. I have two WLAN's, one guest and one staff, the guest netwo

    October 11

  • How can I add the new AP license to HA 5508 WLC?

    Hi, My customer has two 5508 WLC in HA mode and these devices have 250 AP license. Customer bought 50 AP and 50 AP license. But I could not add the license to WLC! When I check the Management>Software Activation> tab there are only two options under

    November 30

  • WLC to use Management Interface & Few more getting started Questions

    Hello, I'm yet to implement the Wireless LAN in one of our client's corporate office. There 40 x 1130AG LWAPP AP's and 4404 WLC with ACS 4.x for the Authentication of the Wireless Clients who is trying to access the LAN. For the WLC to connect to the

    November 30

  • VWLC clients getting DHCP address from management VLAN

    Hi, We have a strange scenario whereby some wireless employees are obtaining addresses from the management VLAN. Some details: DHCP managed by MS DHCP 2008 R2 (in remote data centre) Cisco vWLC AIR-CTVM-K9 running v7.6.110.0 AP's are a mix of 2602 an

    November 30

  • 5508 wlc with 1140 APs and NPS cant connect

    Hi.. let me go off with the equipment setup that I have first.. I have 3 sites each site has  2x 5508 WLC and a few 1140 AP's per site. I also have 3 NPS running on those 3 sites.. I have NPS and dhcp running on the same server... I have a seperate C

    November 30

  • AP unable to download the image from 5508 WLC

    Hi, I have a 5508 WLC connected to 2950 Switch and the LAP 1262 connected to the same default VLAN. My AP's are able to join the controller since they are in the same broadcast domain but They are NOT able to download the image from WLC. When I am lo

    November 30

  • 5508 WLC-6500 Series Switch Etherchannel

    Hi, I have a 5508 controller connected to a 6500 VSS pair. Below is the port channel configuration and port configuration.  I am just wondering whether we still have to configure a load balancing method as cisco recommends "port-channel load-balance

    November 30

  • Can't get 1532i to associate to 5508 WLC running 7.6.130.0

    Greetings, I've got 20 or so APs on a 5508 WLC.  Most of the APs are 1242, one is 3602.  I'm now trying to get a 1532i to associate to the 5508 and it's not happening.  This is the first 1532 on this controller. Also, I got this 1532 AP from a sister

    October 11

  • AIR-CAP3702I booting up in mesh mode and not joining our 5508 WLC

    I have a batch of 30+ AIR-CAP3702I-A-K9 APs that I need to setup but none of them are joining to the 5508 WLC and when I connect a console cable and view the output from the AP it shows that it is trying to initiate in mesh mode. I have read other fo

    October 11

  • Can we use a 5508 WLC in Hong Kong and join 3602 APs in Vietnam to it? Any regulatory contraints?

    Hi friends, I am looking for some wisdom here! Just wondering if I can use a 5508 WLC in Hong Kong and join 3602 APs in Vietnam to it? Any regulatory contsraints / guidelines that would prohibit from doing so? - Regards, Tarun.You have two differnt r

    November 30

  • Cisco 5508-WLC using MS NPS as RADIUS Server for EAP-TLS

    Has anyone experienced a problem getting a Cisco WLC to work with MS NPS server? We've done it before albeit with differnt code versions. I have a Cisco 5508 WLC running 7.0.116.0 code hosting a WLAN configured for WPA2 with 802.1x for authentication

    November 30

  • 5508 WLC - 7.0.98.218 - Local users password reset

    We are required to change passwords every so often at my job. I am trying to change the password  for one of the local user accounts on a  5508 WLC running 7.0.98.218 -  How can I accomplish this task? The option  I get is to remove the users. Any he

    November 30

  • TFTP 'configuration update' from 5508 WLC fails stating reason as '%Error: Config file transfer failed – Unknown error –refer to log'

    Dear Experts, I have two WLCs and other management devices as part of same subnet. I am able to upload 'configs' from all the devices on to my TFTP server. However when I am attempting to do the same from one of my WLC, it is failing consistently sta

    November 30